Signs of over pressure

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

cdschoonie

Sharpshooter
Supporting Member
Special Hen Supporter
Joined
Dec 3, 2017
Messages
1,286
Reaction score
1,093
Location
Kingfisher, OK
Most of you know I’ve been getting my feet wet, and slowly (cautiously) been getting into reloading. I’ve made up several ‘by the book safe zone’ loads of different calibers, in the last 6 months or so, but have yet to shoot any. I’ll be going to the range soon to test my 6.5 CM rounds. Over the process of learning, I’ve both read and seen in videos where they mention to “watch for signs of over pressuring”. I’ve seen and read many things on what to look for with primers, but could someone describe other signs to look for?
 

Aries

Sharpshooter
Special Hen
Joined
Feb 1, 2019
Messages
5,537
Reaction score
8,092
Location
Sapulpa
Difficult extraction or ejection of fired cartridge, easier to tell with a manual extraction like a bolt action or revolver. Split cases, especially if you know they haven't been reloaded multiple times. Excessive recoil (many recommend firing some factory rounds to establish a baseline of "normal" recoil). And as you mentioned, primer condition....
 

TheDoubleD

Sharpshooter
Supporting Member
Special Hen Supporter
Joined
Jun 19, 2018
Messages
526
Reaction score
802
Location
Edmond
Pressure looks something like these.

www.fototime.com_F4B0C6C5E4DC96F_standard.jpg


The first one on the left shows a touch of what appears to be excess headspace in the backed out primer. Primer isn't flattened.

Middle has flattened primer partial head separation. This is definitely a sign of over pressure.

The one on the right fully flattened primer, pierced primer and almost full head separation. Classic pressure signs.

Go back and look at the first case again, it shows the ring from head separation starting also. This is an over pressure sign.

The backed out primer is misleading as this design gun has generous headspace. Maximum go gauge is .010 and backed out primers is a characteristic.

These three cartridges .303 British were fire one after another in a Martini hinge block single shot rifle made around 1889-1890. The gun is marked. "ammunition: .303" The groove diameter of this gun is .303. The .303 British cartridge uses a .311 diameter bullet. Overpressure from firing an oversized .311 bullet in .303 groove barrel.

When the British first developed the .303 British cartridge the experimente with .303, .307 and .311 groove barrels. When finally introduced in 1892/93 they settled on a .311 groove.
 

Okie4570

Sharpshooter
Staff Member
Special Hen Moderator Moderator
Joined
Nov 28, 2010
Messages
22,884
Reaction score
24,637
Location
NWOK
If you follow the reloading manuals and use their powder charges and COL, it's near impossible to ever encounter pressure signs. They're safe to cover their butt. Once you start experimenting and pushing things with powder charges and seating depths, then it's wise to know what to look for. Pistol cartridges even more so imo.
 

cdschoonie

Sharpshooter
Supporting Member
Special Hen Supporter
Joined
Dec 3, 2017
Messages
1,286
Reaction score
1,093
Location
Kingfisher, OK

Latest posts

Top Bottom