Forums
New posts
Search forums
What's new
New posts
New media
New media comments
Latest activity
Classifieds
Media
New media
New comments
Search media
Log in
Register
What's New?
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Navigation
Install the app
Install
More Options
Advertise with us
Contact Us
Close Menu
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Forums
The Range
Handgun Discussion
1911 advice on fixing a failure-to-feed issue
Search titles only
By:
Reply to Thread
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="bearddevil" data-source="post: 1936985" data-attributes="member: 25356"><p>My loads are around 1.135", which is the accepted max OAL for .40. The polishing was to deburr the surface, not remove gross material or change the contours. I'll check the fora, though, and see what I can do about the magazines. I'll mike out the one that works best and see if it's different from the other two.</p></blockquote><p></p>
[QUOTE="bearddevil, post: 1936985, member: 25356"] My loads are around 1.135", which is the accepted max OAL for .40. The polishing was to deburr the surface, not remove gross material or change the contours. I'll check the fora, though, and see what I can do about the magazines. I'll mike out the one that works best and see if it's different from the other two. [/QUOTE]
Insert Quotes…
Verification
Post Reply
Forums
The Range
Handgun Discussion
1911 advice on fixing a failure-to-feed issue
Search titles only
By:
Top
Bottom