Forums
New posts
Search forums
What's new
New posts
New media
New media comments
Latest activity
Classifieds
Media
New media
New comments
Search media
Log in
Register
What's New?
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Navigation
Install the app
Install
More Options
Advertise with us
Contact Us
Close Menu
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Forums
The Range
Ammo & Reloading
300 Blackout loads?
Search titles only
By:
Reply to Thread
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="lkothe" data-source="post: 2920102" data-attributes="member: 30900"><p>I bought what I thought was new brass (I'm going to check vendor) and started to load it. Lip on case was kinda ragged.................... question, is NEW brass ready to go or do you run yours thru the sizing die typically?</p><p>I went ahead and cleaned up the lip inside and out, resized them and tossed em back in the tumbler for a few hours just because.......all clean and shiny, ready for 125's and 1680!</p></blockquote><p></p>
[QUOTE="lkothe, post: 2920102, member: 30900"] I bought what I thought was new brass (I'm going to check vendor) and started to load it. Lip on case was kinda ragged.................... question, is NEW brass ready to go or do you run yours thru the sizing die typically? I went ahead and cleaned up the lip inside and out, resized them and tossed em back in the tumbler for a few hours just because.......all clean and shiny, ready for 125's and 1680! [/QUOTE]
Insert Quotes…
Verification
Post Reply
Forums
The Range
Ammo & Reloading
300 Blackout loads?
Search titles only
By:
Top
Bottom
