Forums
New posts
Search forums
What's new
New posts
New media
New media comments
Latest activity
Classifieds
Media
New media
New comments
Search media
Log in
Register
What's New?
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Navigation
Install the app
Install
More Options
Advertise with us
Contact Us
Close Menu
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Forums
The Water Cooler
General Discussion
3D printable 75 round drum for the AR15
Search titles only
By:
Reply to Thread
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="Johnny" data-source="post: 2368499" data-attributes="member: 14057"><p>I downloaded a model of a stripped lower this morning. It was a billet. Looked pretty damn close to a Seekins. It showed to be 5.8 cubic inches. So probably add another couple inches of support material. So probably $40 in material depending on how it was orientated in the machine. I would figure a solid 12-15 hours in the machine. </p><p></p><p>It has been a couple of years since I ran one though. My time estimates could be off.</p></blockquote><p></p>
[QUOTE="Johnny, post: 2368499, member: 14057"] I downloaded a model of a stripped lower this morning. It was a billet. Looked pretty damn close to a Seekins. It showed to be 5.8 cubic inches. So probably add another couple inches of support material. So probably $40 in material depending on how it was orientated in the machine. I would figure a solid 12-15 hours in the machine. It has been a couple of years since I ran one though. My time estimates could be off. [/QUOTE]
Insert Quotes…
Verification
Post Reply
Forums
The Water Cooler
General Discussion
3D printable 75 round drum for the AR15
Search titles only
By:
Top
Bottom