Reply to Thread

Message

<blockquote data-quote="NightShade" data-source="post: 2569848" data-attributes="member: 29706">Have my rifle that is completed and a built lower and tried this.&nbsp; Agree that 1/4 X 28 is the right thread size for the three lowers I have.&nbsp; Also picked up an extra screw for the grip so I didn&#039;t have to worry about the cutting if the original was just slightly too long.Compared one without to the one with and the reduced takeup is very nice.&nbsp; My wife was even able to tell the difference and liked the &quot;adjusted&quot; one much better.&nbsp; One thing I did notice is that the Anderson stripped lower is not threaded the whole way through so you may want to check that as well and pick up a 1/4 X 28 tap as well instead of making a second trip.&nbsp; The hole is drilled all the way through but the threads stop a bit short on the ones I have so to do a trigger job they will have to be tapped all the way through.[ATTACH]40426[/ATTACH]</blockquote>

[QUOTE="NightShade, post: 2569848, member: 29706"] Have my rifle that is completed and a built lower and tried this. Agree that 1/4 X 28 is the right thread size for the three lowers I have. Also picked up an extra screw for the grip so I didn't have to worry about the cutting if the original was just slightly too long. Compared one without to the one with and the reduced takeup is very nice. My wife was even able to tell the difference and liked the "adjusted" one much better. One thing I did notice is that the Anderson stripped lower is not threaded the whole way through so you may want to check that as well and pick up a 1/4 X 28 tap as well instead of making a second trip. The hole is drilled all the way through but the threads stop a bit short on the ones I have so to do a trigger job they will have to be tapped all the way through. [ATTACH=CONFIG]40426[/ATTACH] [/QUOTE]

Verification