Do you have a projectile in mind? Looking at the 7.62x54R on Hogden may be a place to start.
www.hodgdonreloading.com
Reloading Data Center
www.hodgdonreloading.com
I'm looking at the 220 grain round nose bullets. I'd like to try to get as close to original military load that I can.Do you have a projectile in mind? Looking at the 7.62x54R on Hogden may be a place to start.
Reloading Data Center
If i were to start it out I would go with the low charge for 220 grain on 7.62x54r on Hogdens site and work up from there.
But there are other folks on here with more experience that may tell you better info.
The only load I have ever worked up from zero info is 5.45x39............ I started way low in the powder range there as well . Little skeered lol.
But there are other folks on here with more experience that may tell you better info.
The only load I have ever worked up from zero info is 5.45x39............ I started way low in the powder range there as well . Little skeered lol.
Attachments
I’ll check my manuals but first thing I’d do is determine what chamber pressure your rifle was designed for. Similar sized cartridges could have been designed for vastly different chamber pressures.
I got nothin’, sorry. I did see that it ranges between 40-42Kpsi. I also noticed in the COTW the 8x50r Siamese mentions the 7.62X54r but not the Austrian. One thing that may be of interest and useful info is that in the powder burn rate chart it goes Reloder 7, IMR3031, Benchmark. Wish I could be of more help.
I appreciate everyone's information!! I just tested some loads.
7.62x54r cases sized up to 8mm
197gr fmjbt -.323 8mm-(will switch to a flat base)
38.5gr imr3031
Shot great had no issues.
OSA Really helped me out. I appreciate all the information you guys have. Thanks again!
7.62x54r cases sized up to 8mm
197gr fmjbt -.323 8mm-(will switch to a flat base)
38.5gr imr3031
Shot great had no issues.
OSA Really helped me out. I appreciate all the information you guys have. Thanks again!
"Complete Guide to Handloading"
Philip Sharpe
2nd edition 1941
page 386
Philip Sharpe
2nd edition 1941
page 386
Very cool!! I'll be searching for old reloading manuals now!
my bud said thats a good book. found it online.
one of those "by gosh done that way fer years just fine."
listen to the elders.
one of those "by gosh done that way fer years just fine."
listen to the elders.
