Reply to Thread

Message

<blockquote data-quote="OK Corgi Rancher" data-source="post: 4028128" data-attributes="member: 45773">Both my upper and lower were &quot;Blems&quot;.&nbsp; I can&#039;t find a single flaw in either.&nbsp; When they come up for sale you have to be right on &#039;em.&nbsp; They go fast...I&#039;m sure you know that.I can tell you the tolerances are extremely tight on this upper/lower combo I have.&nbsp; I have to tap the rear pivot pin with a punch to get it out and lightly tap it with a nylon hammer to get it back in.&nbsp; The front is almost as tight though I can push it back in with my hands.The front handguard cap also partially covered the gas tube port in the FSB so I had to fix that, too, so I could get the gas tube into place.I did get the 1/7 twist barrel so it&#039;s not a true clone.&nbsp; But I want to be able to shoot any bullet weight thru it and you can&#039;t tell by looking at it.&nbsp; I like the way it looks.</blockquote>

[QUOTE="OK Corgi Rancher, post: 4028128, member: 45773"] Both my upper and lower were "Blems". I can't find a single flaw in either. When they come up for sale you have to be right on 'em. They go fast...I'm sure you know that. I can tell you the tolerances are extremely tight on this upper/lower combo I have. I have to tap the rear pivot pin with a punch to get it out and lightly tap it with a nylon hammer to get it back in. The front is almost as tight though I can push it back in with my hands. The front handguard cap also partially covered the gas tube port in the FSB so I had to fix that, too, so I could get the gas tube into place. I did get the 1/7 twist barrel so it's not a true clone. But I want to be able to shoot any bullet weight thru it and you can't tell by looking at it. I like the way it looks. [/QUOTE]

Verification