Forums
New posts
Search forums
What's new
New posts
New media
New media comments
Latest activity
Classifieds
Media
New media
New comments
Search media
Log in
Register
What's New?
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Navigation
Install the app
Install
More Options
Advertise with us
Contact Us
Close Menu
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Forums
The Range
Rifle & Shotgun Discussion
Ar problem
Search titles only
By:
Reply to Thread
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="uncle money bags" data-source="post: 2319805" data-attributes="member: 8377"><p>Are you talking overall length or case length s4f? It sounds more like a sizing issue to me.</p><p>More specifically, like the cases were not properly full length resized and are too large at the web. This would explain why they seat partially and then become stuck. The same thing could happen if the brass is not trimmed to length, but those dont seem to be as hard to extract as the op says. Also, the hanging up on the feed ramp could be because the previous round was so difficult to extract that the momentum of the bcg was retarded to point of not being able to fully strip the next round from the mag.</p><p></p><p>For the op,you should never need to force around into the chamber with a hammer! If the round is that difficult, something is very wrong and you should stop and fix it.</p><p>Op, do you have any pics or measurements of the reloads that did not chamber correctly?</p><p></p><p>I think it would be well worth your time to take a short road trip over to FBT with the rifle and ammo for them to look at. I promise you will learn alot from the experience.</p></blockquote><p></p>
[QUOTE="uncle money bags, post: 2319805, member: 8377"] Are you talking overall length or case length s4f? It sounds more like a sizing issue to me. More specifically, like the cases were not properly full length resized and are too large at the web. This would explain why they seat partially and then become stuck. The same thing could happen if the brass is not trimmed to length, but those dont seem to be as hard to extract as the op says. Also, the hanging up on the feed ramp could be because the previous round was so difficult to extract that the momentum of the bcg was retarded to point of not being able to fully strip the next round from the mag. For the op,you should never need to force around into the chamber with a hammer! If the round is that difficult, something is very wrong and you should stop and fix it. Op, do you have any pics or measurements of the reloads that did not chamber correctly? I think it would be well worth your time to take a short road trip over to FBT with the rifle and ammo for them to look at. I promise you will learn alot from the experience. [/QUOTE]
Insert Quotes…
Verification
Post Reply
Forums
The Range
Rifle & Shotgun Discussion
Ar problem
Search titles only
By:
Top
Bottom