Reply to Thread

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

Message: <blockquote data-quote="dennishoddy" data-source="post: 3651898" data-attributes="member: 5412">I had issues with .223 sticking. Standard procedure by RCBS is to run the sizing die to full extension where it touches the shell plate, run it back to the top and give it 1/8 turn to establish cam over. What was happening is that the "cam over" while sizing a round wasn't actually at full stroke. Cam over was taking place before the die made a complete sizing. Upon consultation with RCBS they said to run the die down to the shell plate and give it 1/4 turn vs the 1/8 in the instructions. My issues went away.</blockquote>