Forums
New posts
Search forums
What's new
New posts
New media
New media comments
Latest activity
Classifieds
Media
New media
New comments
Search media
Log in
Register
What's New?
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Navigation
Install the app
Install
More Options
Advertise with us
Contact Us
Close Menu
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Forums
The Water Cooler
Photo Album
Completed M16-A1 Project
Search titles only
By:
Reply to Thread
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="ez bake" data-source="post: 1085220" data-attributes="member: 229"><p>That's cool man - I've got a couple of the Noveske's Single QD sling-plate (its actually there in place of the standard M4 end-plate) and I had just never seen the DD single-point connector before.</p><p></p><p>You might check out the Noveske - I can close my stock all the way with a QD connected to it.</p><p></p><p>So here's another silly question - if you buy a registered lower, can you then buy all the M16 FCG parts without hassle or do you have to have some special permission to get those as well?</p><p></p><p>Since yours is a registered M16 A1 lower, can you do get the FCG parts for 3 round burst or are you limited to only what was on the A1?</p><p></p><p>What's an average cost on a stripped Pre-86 registered lower (or can you even find them and/or did you buy yours completed)?</p></blockquote><p></p>
[QUOTE="ez bake, post: 1085220, member: 229"] That's cool man - I've got a couple of the Noveske's Single QD sling-plate (its actually there in place of the standard M4 end-plate) and I had just never seen the DD single-point connector before. You might check out the Noveske - I can close my stock all the way with a QD connected to it. So here's another silly question - if you buy a registered lower, can you then buy all the M16 FCG parts without hassle or do you have to have some special permission to get those as well? Since yours is a registered M16 A1 lower, can you do get the FCG parts for 3 round burst or are you limited to only what was on the A1? What's an average cost on a stripped Pre-86 registered lower (or can you even find them and/or did you buy yours completed)? [/QUOTE]
Insert Quotes…
Verification
Post Reply
Forums
The Water Cooler
Photo Album
Completed M16-A1 Project
Search titles only
By:
Top
Bottom
