Reply to Thread

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

Message: <blockquote data-quote="1Mudman" data-source="post: 3848899" data-attributes="member: 51234"><p>I think I would just remove the decap pin from the sizing die and resize, recharge and seat the bullet. Use a Lee locking case holder with proper head size in a drill and clean with steel wool. Beautiful finished product in a few seconds. I have body dies with no primer or neck sizing nubs in them that work great also. You could always just use a good neck die after you clean them. Steel wool in a drill is quick and a low percentage of screwing up you primer. I have had to re-do several times over the years and Ya! it kind of sucks but is better than ruining a good chamber from bad brass.</p></blockquote><p></p>