depriming live primers.

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

blutch

Sharpshooter
Special Hen
Joined
Jul 20, 2009
Messages
879
Reaction score
0
Location
OKC
I have a case full of messed up cartridges that I loaded. I plan to pull them all apart and salvage the cases and bullets. Can I deprime them using my Dillon SDB safely and then re-use them?

They are Federal Magnum Small Pistol Primers.

B
 

Bubber

Sharpshooter
Special Hen
Joined
Dec 15, 2008
Messages
126
Reaction score
0
Location
Near Hanna,
Blutch, You can and if you are using them in an auto there should be no large problem. In a Revo it may make a slight difference if the action has beeen lightened. if they are not deformed I usually pull the bullet, (with an inertial bullet puller) and add powder and bullet again without depriming. But if you need to resize you can either pull out the decapping pin and resize the cases and load on the SBD. That way you don't go through all the motions just to dump the powder as it is a auto indexing machine. Just my thoughts. Later rdd
 

alank2

Sharpshooter
Supporting Member
Special Hen Supporter
Joined
Jul 14, 2005
Messages
2,645
Reaction score
589
Location
Broken Arrow
Hi,

Be careful, federal primers are softer than most and tend to be more sensitive to going bang. How many are you talking about? I'd probably sell the brass as primed brass before extracting too many live primers myself...

Good luck,

Alan
 

blutch

Sharpshooter
Special Hen
Joined
Jul 20, 2009
Messages
879
Reaction score
0
Location
OKC
These are for auto rounds and some of the primers are not seated correctly. So, I need to salvage the primer if possible.

B
 
Joined
Dec 9, 2008
Messages
87,928
Reaction score
70,788
Location
Ponca City Ok
+1. But if you do need to deprime, I do it with a dedicated depriming die and just be gentle. They should come right out and I have always been able to reuse them.

Dang, I've been reloading for many years and never heard of a depriming die.
I've always pulled the bullet with a collet style puller, and snaped the cap in the weapon it was designed for.
I see where you say they can be re-used.
Ever had any back out after reloading the pushed out primers? Just looking for more info:D
 

DRC458

Sharpshooter
Supporting Member
Special Hen Supporter
Joined
Mar 1, 2006
Messages
12,013
Reaction score
11,838
Location
Enid, OK.
Dang, I've been reloading for many years and never heard of a depriming die.
I've always pulled the bullet with a collet style puller, and snaped the cap in the weapon it was designed for.
I see where you say they can be re-used.
Ever had any back out after reloading the pushed out primers? Just looking for more info:D

I imagine what DG is talking about is a universal decapping die. I have one (Lyman) which I hardly ever use. However, over the years, I have pushed out (carefully) quite a few primers with the standard sizing/decapping die and never had a problem. Notice, I did say carefully!
 

Latest posts

Top Bottom