Reply to Thread

Message

<blockquote data-quote="NikatKimber" data-source="post: 519408" data-attributes="member: 423">I just priced them out, and for the full deal on a 650, the cost for a full switch is over $200 without an additional powder check. (not sure how they are used) Almost $300 with it.Total&nbsp; &nbsp; &nbsp; &nbsp; &nbsp; &nbsp; &nbsp; &nbsp; &nbsp; &nbsp; &nbsp; &nbsp; &nbsp; &nbsp; &nbsp; &nbsp; &nbsp; $297.00Conversion Kit&nbsp; &nbsp; &nbsp; &nbsp; &nbsp; &nbsp; &nbsp; &nbsp; &nbsp; $74.00Carbide 3-Die Set&nbsp; &nbsp; &nbsp; &nbsp; &nbsp; &nbsp; &nbsp; &nbsp; &nbsp; $61.00Quick Change&nbsp; &nbsp; &nbsp; &nbsp; &nbsp; &nbsp; &nbsp; &nbsp; &nbsp; $96.00Powder Measure Toolhead and Powder DiePowdercheck System&nbsp; &nbsp; &nbsp; &nbsp; &nbsp; &nbsp; &nbsp; $66.00For the 550, just less than $200.&nbsp; &nbsp; &nbsp; &nbsp; &nbsp; &nbsp; &nbsp; &nbsp; &nbsp; &nbsp; &nbsp; &nbsp; &nbsp; &nbsp; &nbsp; &nbsp; &nbsp; &nbsp;&nbsp; $195.00Conversion Kit&nbsp; &nbsp; &nbsp; &nbsp; &nbsp; &nbsp; &nbsp; &nbsp; $42.00Carbide 3-Die Set&nbsp; &nbsp; &nbsp; &nbsp; &nbsp; &nbsp; &nbsp; &nbsp; $61.00Deluxe Quick Change&nbsp; &nbsp; &nbsp; &nbsp; &nbsp; &nbsp; $92.00&nbsp; &nbsp; &nbsp; &nbsp; &nbsp; &nbsp; &nbsp; (toolhead, powder die, powder measure)I know I wouldn&#039;t need the whole new powder measure, but at least for the most common calibers (for me, 9mm and .38 target loads) it would be nice to keep the dies and powder settings without having to adjust them.</blockquote>

[QUOTE="NikatKimber, post: 519408, member: 423"] I just priced them out, and for the full deal on a 650, the cost for a full switch is over $200 without an additional powder check. (not sure how they are used) Almost $300 with it. Total $297.00 Conversion Kit $74.00 Carbide 3-Die Set $61.00 Quick Change $96.00 Powder Measure Toolhead and Powder Die Powdercheck System $66.00 For the 550, just less than $200. $195.00 Conversion Kit $42.00 Carbide 3-Die Set $61.00 Deluxe Quick Change $92.00 (toolhead, powder die, powder measure) I know I wouldn't need the whole new powder measure, but at least for the most common calibers (for me, 9mm and .38 target loads) it would be nice to keep the dies and powder settings without having to adjust them. [/QUOTE]

Verification