Forums
New posts
Search forums
What's new
New posts
New media
New media comments
Latest activity
Classifieds
Media
New media
New comments
Search media
Log in
Register
What's New?
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Navigation
Install the app
Install
More Options
Advertise with us
Contact Us
Close Menu
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Forums
The Range
Rifle & Shotgun Discussion
dpms panther lite 16
Search titles only
By:
Reply to Thread
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="KurtM" data-source="post: 788772" data-attributes="member: 6064"><p>I think a lot of people would be very surprised as to who buy,s DPMS "blanks" and re-marks them. I am willing to bet that if you removed all the markings from a DPMS rifle and all the markings from a super cool XYZ builder, then anodized each of them at the same place no-one could tell the difference. I think a lot of folks would be real surprised at who buys blanks from Cerro, Anchor Harvey,Mueller Brass...etc. and mills them and badged them as their own. There are darn few builders that make all parts in house and most of the smaller "high end" builders don't own their own forge, nor the milling machines that produce a completed upper/lower.</p><p></p><p>This debate is kind of like saying that the polymer in the grip of an SVI pistol is far superior to the polymer in the grip of an STI pistol. KurtM</p></blockquote><p></p>
[QUOTE="KurtM, post: 788772, member: 6064"] I think a lot of people would be very surprised as to who buy,s DPMS "blanks" and re-marks them. I am willing to bet that if you removed all the markings from a DPMS rifle and all the markings from a super cool XYZ builder, then anodized each of them at the same place no-one could tell the difference. I think a lot of folks would be real surprised at who buys blanks from Cerro, Anchor Harvey,Mueller Brass...etc. and mills them and badged them as their own. There are darn few builders that make all parts in house and most of the smaller "high end" builders don't own their own forge, nor the milling machines that produce a completed upper/lower. This debate is kind of like saying that the polymer in the grip of an SVI pistol is far superior to the polymer in the grip of an STI pistol. KurtM [/QUOTE]
Insert Quotes…
Verification
Post Reply
Forums
The Range
Rifle & Shotgun Discussion
dpms panther lite 16
Search titles only
By:
Top
Bottom