Forums
New posts
Search forums
What's new
New posts
New media
New media comments
Latest activity
Classifieds
Media
New media
New comments
Search media
Log in
Register
What's New?
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Navigation
Install the app
Install
More Options
Advertise with us
Contact Us
Close Menu
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Forums
The Water Cooler
General Discussion
Garage heads advice needed
Search titles only
By:
Reply to Thread
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="SlugSlinger" data-source="post: 3170758" data-attributes="member: 7248"><p>I have a 2 foot long crescent wrench and if we can figure out a way to hold the other end, we can apply a lot more torque than the straps will. Maybe use a 1/4" piece of plate or bar stock in a vice and set the end with the slots cut on that to hold and keep it from turning.</p></blockquote><p></p>
[QUOTE="SlugSlinger, post: 3170758, member: 7248"] I have a 2 foot long crescent wrench and if we can figure out a way to hold the other end, we can apply a lot more torque than the straps will. Maybe use a 1/4" piece of plate or bar stock in a vice and set the end with the slots cut on that to hold and keep it from turning. [/QUOTE]
Insert Quotes…
Verification
Post Reply
Forums
The Water Cooler
General Discussion
Garage heads advice needed
Search titles only
By:
Top
Bottom
