Reply to Thread

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

Message: <blockquote data-quote="Perplexed" data-source="post: 3170926" data-attributes="member: 7157">Well, I tried this redneck approach, with a pair of channel lock pliers clamped tightly, then duct-taped, around the stem of the base cover.  Then I used a pneumatic hammer with the pliers handles in the fork, and the strap wrench in the vise tight around the housing.  Both the pliers and wrench held admirably, but even with the jack hammering action at 90 psi, the thing simply did not budge. I even tried it in the other direction, just in case it was a LH thread.  Nope. Back to the drawing board...[ATTACH=full]126736[/ATTACH]</blockquote>