Forums
New posts
Search forums
What's new
New posts
New media
New media comments
Latest activity
Classifieds
Media
New media
New comments
Search media
Log in
Register
What's New?
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Navigation
Install the app
Install
More Options
Advertise with us
Contact Us
Close Menu
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Forums
Hobbies & Interests
Gearheads
Gate hinge placement?
Search titles only
By:
Reply to Thread
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="SlugSlinger" data-source="post: 3831829" data-attributes="member: 7248"><p>This ended up being a little more work than I though it would be. I cut the bottom hinges off the post and adjusted them out so the gates will touch to keep them from sagging. If I did it again I would make the plates like redmule mentions. I would of needed to cut the width down on the gates to make that design work since I already had the gates welded up.</p><p></p><p>I still need to make a latch and the gate drop rods. And seal the cedar boards. These are really more of a privacy fence than a gate that will be used much.</p><p></p><p>[ATTACH]291904[/ATTACH]</p><p></p><p>[ATTACH=full]291905[/ATTACH]</p><p></p><p></p><p>[ATTACH=full]291907[/ATTACH]</p><p></p><p>[ATTACH=full]291906[/ATTACH]</p></blockquote><p></p>
[QUOTE="SlugSlinger, post: 3831829, member: 7248"] This ended up being a little more work than I though it would be. I cut the bottom hinges off the post and adjusted them out so the gates will touch to keep them from sagging. If I did it again I would make the plates like redmule mentions. I would of needed to cut the width down on the gates to make that design work since I already had the gates welded up. I still need to make a latch and the gate drop rods. And seal the cedar boards. These are really more of a privacy fence than a gate that will be used much. [ATTACH]291904[/ATTACH] [ATTACH type="full"]291905[/ATTACH] [ATTACH type="full"]291907[/ATTACH] [ATTACH type="full"]291906[/ATTACH] [/QUOTE]
Insert Quotes…
Verification
Post Reply
Forums
Hobbies & Interests
Gearheads
Gate hinge placement?
Search titles only
By:
Top
Bottom
