Go/no go gauges

[Permanent37]

What brand do you guys recommend? I build enough AR’s so I think it’s time to invest in some for 5.56 and 308.


Sent from my iPhone using Tapatalk

 

[lasher]

unless you have a lathe go/nogo tools aren't going to do much for you, cept rob you wallet

 

[Permanent37]

unless you have a lathe go/nogo tools aren't going to do much for you, cept rob you wallet

Why’s that?


Sent from my iPhone using Tapatalk

 

[lasher]

if a bolt is out of spec you either get another bolt or turn the lugs, might need a reamer as well. i've only had one bolt that was too tight, sent it back for another one, worked fine since

 

[Permanent37]

if a bolt is out of spec you either get another bolt or turn the lugs, might need a reamer as well. i've only had one bolt that was too tight, sent it back for another one, worked fine since

Well yeah but you need gauges to determine that.


Sent from my iPhone using Tapatalk

 

[lasher]

i load up dummy rounds, no primer or powder, those are my gauges. if you are determined to get some Wilson tools are hard to beat. if you ever need a set of 6.8 spc i have a set that have never once been used in 5 or so years