Forums
New posts
Search forums
What's new
New posts
New media
New media comments
Latest activity
Classifieds
Media
New media
New comments
Search media
Log in
Register
What's New?
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Navigation
Install the app
Install
More Options
Advertise with us
Contact Us
Close Menu
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Forums
Hobbies & Interests
Gearheads
Homemade valve grinder Cost $0
Search titles only
By:
Reply to Thread
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="swampratt" data-source="post: 3107637" data-attributes="member: 15054"><p>You are right. I did end up doubling them up. I could see it just barely flex with 1 disc and then I added another.</p><p>I applied light pressure against the disc while it was spinning high speed and my drill was spinning the valve the other direction.</p><p>That is why It took 3 minutes to grind the valve instead of a few seconds like in the video.</p><p></p><p>But my valves were pitted quite deep.</p><p>My valve contacted the disc near the middle not on the outer edge so less flex there for sure.</p></blockquote><p></p>
[QUOTE="swampratt, post: 3107637, member: 15054"] You are right. I did end up doubling them up. I could see it just barely flex with 1 disc and then I added another. I applied light pressure against the disc while it was spinning high speed and my drill was spinning the valve the other direction. That is why It took 3 minutes to grind the valve instead of a few seconds like in the video. But my valves were pitted quite deep. My valve contacted the disc near the middle not on the outer edge so less flex there for sure. [/QUOTE]
Insert Quotes…
Verification
Post Reply
Forums
Hobbies & Interests
Gearheads
Homemade valve grinder Cost $0
Search titles only
By:
Top
Bottom