Forums
New posts
Search forums
What's new
New posts
New media
New media comments
Latest activity
Classifieds
Media
New media
New comments
Search media
Log in
Register
What's New?
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Navigation
Install the app
Install
More Options
Advertise with us
Contact Us
Close Menu
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Forums
The Range
Ammo & Reloading
Hornady 165 Grain SST in 308, what are you pushing this bullet to?
Search titles only
By:
Reply to Thread
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="rockchalk06" data-source="post: 3911771" data-attributes="member: 40794"><p>It's my preferred powder for my 168 ELDM's, but they are seated way out for my bolt gun. These are seated at 2.750" according to my Hornady book. It's barely inside the crimp ring too. These are gas gun loads too.</p><p></p><p>When I was loading my 175 grain with 4064 at 2.800", I'd do the same and I'd run my tumbler on the bench. Packed it down to keep it from being compressed too much. My funnel has an itty bitty hole so it assists with this too.</p><p></p><p>If I don't get what I'm looking for with Tac, I may try this again with 4064. Really hoping Tac works out though. It meters so well from my Hornady Lock n Load measure. 4064 is a PITA.</p><p></p><p>On a side note, it may be time to add an RCBS link to my bench</p></blockquote><p></p>
[QUOTE="rockchalk06, post: 3911771, member: 40794"] It's my preferred powder for my 168 ELDM's, but they are seated way out for my bolt gun. These are seated at 2.750" according to my Hornady book. It's barely inside the crimp ring too. These are gas gun loads too. When I was loading my 175 grain with 4064 at 2.800", I'd do the same and I'd run my tumbler on the bench. Packed it down to keep it from being compressed too much. My funnel has an itty bitty hole so it assists with this too. If I don't get what I'm looking for with Tac, I may try this again with 4064. Really hoping Tac works out though. It meters so well from my Hornady Lock n Load measure. 4064 is a PITA. On a side note, it may be time to add an RCBS link to my bench [/QUOTE]
Insert Quotes…
Verification
Post Reply
Forums
The Range
Ammo & Reloading
Hornady 165 Grain SST in 308, what are you pushing this bullet to?
Search titles only
By:
Top
Bottom
