Forums
New posts
Search forums
What's new
New posts
New media
New media comments
Latest activity
Classifieds
Media
New media
New comments
Search media
Log in
Register
What's New?
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Navigation
Install the app
Install
More Options
Advertise with us
Contact Us
Close Menu
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Forums
The Range
Ammo & Reloading
Lead, lead and more lead or maybe something else
Search titles only
By:
Reply to Thread
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="ok-22shooter" data-source="post: 4332312" data-attributes="member: 42477"><p>transferred about 500# to the Linotype slugs to my process facility today. will make another run later in the week. this drum had much less of the loose fines that the first drum had. the third drum appeared to a bit of a mix of cleaner and some with fines at the bottom. trying to get the weight of the drums so I can 2 wheel them on and off a trailer.</p><p></p><p>made progress on my big smelter pot. cut the disc for the floor of the pot and got the outside circumfrential groove welded. will have a buddy run a "good" mig fillet on the inside to make sure there is a good seal. my welding has deteriorated over the years. I ground out several areas and tried to re-weld. did not have time to test with water b4 I had to head for the house.</p><p></p><p>I want to buy a dual flame pattern burner for the pot, lots of heat. I may be able to put a on/off valve running off a PID controller on one of the burner patterns to help control the temp. putting up some of the as is raw slugs for sale in classified to fund the pot.</p></blockquote><p></p>
[QUOTE="ok-22shooter, post: 4332312, member: 42477"] transferred about 500# to the Linotype slugs to my process facility today. will make another run later in the week. this drum had much less of the loose fines that the first drum had. the third drum appeared to a bit of a mix of cleaner and some with fines at the bottom. trying to get the weight of the drums so I can 2 wheel them on and off a trailer. made progress on my big smelter pot. cut the disc for the floor of the pot and got the outside circumfrential groove welded. will have a buddy run a "good" mig fillet on the inside to make sure there is a good seal. my welding has deteriorated over the years. I ground out several areas and tried to re-weld. did not have time to test with water b4 I had to head for the house. I want to buy a dual flame pattern burner for the pot, lots of heat. I may be able to put a on/off valve running off a PID controller on one of the burner patterns to help control the temp. putting up some of the as is raw slugs for sale in classified to fund the pot. [/QUOTE]
Insert Quotes…
Verification
Post Reply
Forums
The Range
Ammo & Reloading
Lead, lead and more lead or maybe something else
Search titles only
By:
Top
Bottom