Forums
New posts
Search forums
What's new
New posts
New media
New media comments
Latest activity
Classifieds
Media
New media
New comments
Search media
Log in
Register
What's New?
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Navigation
Install the app
Install
More Options
Advertise with us
Contact Us
Close Menu
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Forums
The Range
Rifle & Shotgun Discussion
Magpul trigger guard dosent fit my dpms lower
Search titles only
By:
Reply to Thread
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="ez bake" data-source="post: 1087838" data-attributes="member: 229"><p>That's why I recommend the MOE trigger guard to folks who aren't sure about their lowers - you can usually force it into place since its made of plastic. </p><p></p><p>One trick that worked with the MOE was to put the screw into the trigger guard all the way until the trigger guard would fit in between the ears on the lower and then unscrew the screw until it was holding the guard in place - this way the threads were at least started before you did the "forcing".</p><p></p><p>If you're running a MIAD, just get the trigger-guard piece for it and put it in there and yank the alum one (or get a MOE and sell your alum one - I actually need another winter trigger guard, so I'd buy it).</p><p></p><p>I'd be careful about forcing stuff into those trigger-guard ears (both front and rear) because if you break one of those ears, you have to either weld, JB Weld, or get another lower (and it happens a lot more often than you think).</p></blockquote><p></p>
[QUOTE="ez bake, post: 1087838, member: 229"] That's why I recommend the MOE trigger guard to folks who aren't sure about their lowers - you can usually force it into place since its made of plastic. One trick that worked with the MOE was to put the screw into the trigger guard all the way until the trigger guard would fit in between the ears on the lower and then unscrew the screw until it was holding the guard in place - this way the threads were at least started before you did the "forcing". If you're running a MIAD, just get the trigger-guard piece for it and put it in there and yank the alum one (or get a MOE and sell your alum one - I actually need another winter trigger guard, so I'd buy it). I'd be careful about forcing stuff into those trigger-guard ears (both front and rear) because if you break one of those ears, you have to either weld, JB Weld, or get another lower (and it happens a lot more often than you think). [/QUOTE]
Insert Quotes…
Verification
Post Reply
Forums
The Range
Rifle & Shotgun Discussion
Magpul trigger guard dosent fit my dpms lower
Search titles only
By:
Top
Bottom