Forums
New posts
Search forums
What's new
New posts
New media
New media comments
Latest activity
Classifieds
Media
New media
New comments
Search media
Log in
Register
What's New?
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Navigation
Install the app
Install
More Options
Advertise with us
Contact Us
Close Menu
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Forums
The Range
Gunsmithing & Repairs
Mass produced revolver question
Search titles only
By:
Reply to Thread
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="Letfreedomring" data-source="post: 4085760" data-attributes="member: 50298"><p>I was wondering if anyone knows how much hand fitting/timing goes into mass produced revolvers, particularly with lower-end offerings like taurus? Do they just throw them together, check for function, then ship them out till they have a problem/warranty claim then hand fit the parts or do they hand fit each one that comes off the line? </p><p>Reason I ask is I've got a wild hair up my arse that if I can buy a used complete cylinder and crane for same model and caliber as the one I have, I'd like to convert the used one to 9mm from .357mag. What are the chances it will work and be in time in my revolver? Is this more trouble than it's worth or could this make into a nice convertible 8 shooter?</p></blockquote><p></p>
[QUOTE="Letfreedomring, post: 4085760, member: 50298"] I was wondering if anyone knows how much hand fitting/timing goes into mass produced revolvers, particularly with lower-end offerings like taurus? Do they just throw them together, check for function, then ship them out till they have a problem/warranty claim then hand fit the parts or do they hand fit each one that comes off the line? Reason I ask is I've got a wild hair up my arse that if I can buy a used complete cylinder and crane for same model and caliber as the one I have, I'd like to convert the used one to 9mm from .357mag. What are the chances it will work and be in time in my revolver? Is this more trouble than it's worth or could this make into a nice convertible 8 shooter? [/QUOTE]
Insert Quotes…
Verification
Post Reply
Forums
The Range
Gunsmithing & Repairs
Mass produced revolver question
Search titles only
By:
Top
Bottom
