Forums
New posts
Search forums
What's new
New posts
New media
New media comments
Latest activity
Classifieds
Media
New media
New comments
Search media
Log in
Register
What's New?
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Navigation
Install the app
Install
More Options
Advertise with us
Contact Us
Close Menu
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Forums
The Range
Gunsmithing & Repairs
My 6.5 Grendel Remington 700 in progress
Search titles only
By:
Reply to Thread
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="Master Carper" data-source="post: 3169409" data-attributes="member: 15527"><p>Last pictures of the day.</p><p></p><p>I drilled and tapped the Remington action and scope base for the larger 8-40 screws, and when they are installed, the base will be bedded to the action and the screws will be torqued to 80 inch pounds. I see a lot of guys who have not seen 8-40 screws before, so I have a picture of them beside the smaller and more standard 6-48 screws.</p><p></p><p>I checked my vise to be sure it was square, and over the 6 inches of travel side to side, it was within .0005 and looking good.</p><p></p><p>Not bragging on my work, because this is how I set everything up, but the accuracy of this level is .0005 over 10" and as you can in the picture, it is dead level!</p><p></p><p>[ATTACH=full]126417[/ATTACH] </p><p></p><p>[ATTACH=full]126418[/ATTACH] [ATTACH=full]126419[/ATTACH]</p></blockquote><p></p>
[QUOTE="Master Carper, post: 3169409, member: 15527"] Last pictures of the day. I drilled and tapped the Remington action and scope base for the larger 8-40 screws, and when they are installed, the base will be bedded to the action and the screws will be torqued to 80 inch pounds. I see a lot of guys who have not seen 8-40 screws before, so I have a picture of them beside the smaller and more standard 6-48 screws. I checked my vise to be sure it was square, and over the 6 inches of travel side to side, it was within .0005 and looking good. Not bragging on my work, because this is how I set everything up, but the accuracy of this level is .0005 over 10" and as you can in the picture, it is dead level! [ATTACH=full]126417[/ATTACH] [ATTACH=full]126418[/ATTACH] [ATTACH=full]126419[/ATTACH] [/QUOTE]
Insert Quotes…
Verification
Post Reply
Forums
The Range
Gunsmithing & Repairs
My 6.5 Grendel Remington 700 in progress
Search titles only
By:
Top
Bottom
