Forums
New posts
Search forums
What's new
New posts
New media
New media comments
Latest activity
Classifieds
Media
New media
New comments
Search media
Log in
Register
What's New?
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Navigation
Install the app
Install
More Options
Advertise with us
Contact Us
Close Menu
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Forums
The Range
Rifle & Shotgun Discussion
Ok, so I went and did it now.
Search titles only
By:
Reply to Thread
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="Shinneryfarmer" data-source="post: 4087882" data-attributes="member: 46291"><p>Made many a pins in the field over the years out of Screwdrivers. Cut the handle off chuck up in a drill, file close to size, then finish with sand paper and cut to length. If they need braded, drill a hole in each end about 2/3 rds of pin size. This will allow them to roll over on the edges.</p></blockquote><p></p>
[QUOTE="Shinneryfarmer, post: 4087882, member: 46291"] Made many a pins in the field over the years out of Screwdrivers. Cut the handle off chuck up in a drill, file close to size, then finish with sand paper and cut to length. If they need braded, drill a hole in each end about 2/3 rds of pin size. This will allow them to roll over on the edges. [/QUOTE]
Insert Quotes…
Verification
Post Reply
Forums
The Range
Rifle & Shotgun Discussion
Ok, so I went and did it now.
Search titles only
By:
Top
Bottom