Reply to Thread

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

Message: <blockquote data-quote="918evo" data-source="post: 4285486" data-attributes="member: 6001"><p>The wheel-bearing nut probably just needs to be tightened up a bit. It needs to be jacked up, pop off the dust cover, remove the cotter pin and castle nut cover thingy, remove washer and nut, insert some grease and tighten the nut to 72(ish) ft lbs, back it off, then retorque to 13 ft lbs. I've done it a few times for a customer's pathfinder over the years. Takes about 30 minutes to do both sides and it makes a world of difference in the way it drives afterwards.</p></blockquote><p></p>