Reply to Thread

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

Message: <blockquote data-quote="Cowcatcher" data-source="post: 3985126" data-attributes="member: 43171"><p>Cutter is a Thermal Dynamics Cutmaster 42. It will run on 110 or 220. Of course just like a dual power welder it will cut thicker on 220. I actually ran it on a remote job cutting patch sheets for a feed bin. Powered it off the engine drive welder and supplied air with portable engine drive compressor. You need DRY air. A water separator isn’t expensive. My shop compressor is 120 gallons. You need nowhere near that to run a plasma but I can’t give you accurate specs.</p></blockquote><p></p>