Reply to Thread

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

Message: <blockquote data-quote="ok-22shooter" data-source="post: 4187308" data-attributes="member: 42477"><p>Found issue with why cases were not sliding into shell plate. 300BO requires the riser on the case feed. When I installed the riser, it was not flush with the base on the surface that pushes case into shell holder, about 1/64" further in than it should have been. Riser leading edge was pushing top case forward and the tilted case rim was dragging into the shell holder. Now running very slick. It's the little details that we miss and can sometimes give us issues.</p></blockquote><p></p>