Reply to Thread

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

Message: <blockquote data-quote="swampratt" data-source="post: 2699722" data-attributes="member: 15054">NOPE but using the same parts  but cuts the time a bunch.Instead of the shell holder being chucked in the drill I just hold the shell holder in my hand and install the case, does not need to be as tight.Then take the cutter and case length gauge and chuck it in the $39 bench top drill press and spin the cutter.Feed the case  up by hand and the spinning cutter cuts it while you hold the case and the shell holder.Way way quicker and no more fighting trying to unlock the case from the holder as you do not need to tighten it so much as now you are holding the case in hand.My buddy has a high dollar setup for trimming cases and it is possibly even faster.it is blue and a lever flips and you insert case close lever and then flip another and it feeds the case until it stops.done.Holds the case really square and tight. think it is around 300 or more</blockquote>