Reply to Thread

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

Message: <blockquote data-quote="NINEROUND" data-source="post: 3016018" data-attributes="member: 17429"><p>Ideally I would have had it dovetailed. However, I don't have or know anyone that has a lathe or the proper die to cut it. I may still end up having that done at some point if this doesn't work out. As far as being too high, I have yet to fire it with this sight, so Im not sure where it will hit. My hope it to put the green dot on target and hopefully it will be close. It is after all, a short, cylinder bore shotgun meant for across the room dealings. A little high or low shouldn't matter that much. If I can find a clamp-on ghost ring rear, I may venture into the deer woods with it at some point.</p></blockquote><p></p>