Forums
New posts
Search forums
What's new
New posts
New media
New media comments
Latest activity
Classifieds
Media
New media
New comments
Search media
Log in
Register
What's New?
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Navigation
Install the app
Install
More Options
Advertise with us
Contact Us
Close Menu
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Forums
The Range
Ammo & Reloading
Starter setup, i bit the bullet
Search titles only
By:
Reply to Thread
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="lkothe" data-source="post: 2477249" data-attributes="member: 30900"><p>Worked up 6 "dummy" loads to check what I was doing. First two were seated a bit deep, got that ironed out with COL at 1.125 on the other four. Adjusted the taper crimp down. Loads will drop in my M&P barrel with no problem....after I did this I checked all the rest of the brass I had left and all of it would drop in the barrel ,,,, hmmmm going to assume the case flare was pretty mild.</p><p>Worked on the Perfect powder dropper till I was able to equal the 4.5 gr starting load. </p><p></p><p>Primed 10 cases on the ram, filled with 4.5 gr of SR 7625, pressed the bullets. All went well as best that I can tell. Checked first and last loads of powder, on the money. Checked all COL, all but one were 1.125 - 1.127, one was 1.131.</p><p></p><p>DNO</p></blockquote><p></p>
[QUOTE="lkothe, post: 2477249, member: 30900"] Worked up 6 "dummy" loads to check what I was doing. First two were seated a bit deep, got that ironed out with COL at 1.125 on the other four. Adjusted the taper crimp down. Loads will drop in my M&P barrel with no problem....after I did this I checked all the rest of the brass I had left and all of it would drop in the barrel ,,,, hmmmm going to assume the case flare was pretty mild. Worked on the Perfect powder dropper till I was able to equal the 4.5 gr starting load. Primed 10 cases on the ram, filled with 4.5 gr of SR 7625, pressed the bullets. All went well as best that I can tell. Checked first and last loads of powder, on the money. Checked all COL, all but one were 1.125 - 1.127, one was 1.131. DNO [/QUOTE]
Insert Quotes…
Verification
Post Reply
Forums
The Range
Ammo & Reloading
Starter setup, i bit the bullet
Search titles only
By:
Top
Bottom
