Forums
New posts
Search forums
What's new
New posts
New media
New media comments
Latest activity
Classifieds
Media
New media
New comments
Search media
Log in
Register
What's New?
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Navigation
Install the app
Install
More Options
Advertise with us
Contact Us
Close Menu
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Forums
The Range
Gunsmithing & Repairs
Update on Boyd At One stock
Search titles only
By:
Reply to Thread
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="steelfingers" data-source="post: 2995207" data-attributes="member: 38658"><p>Update. Pic one shows the mag catch that was not fitting in and needed a little sanding on the round end to fit. Once I did that I guess it positioned the take down screw where it would catch. When this was done I dropped in the barrel and attached. You will see a pic of the mag and note the mag latch is not low enough to capture the mag catch. Also still a bit of a tight fit. I can see some additional sanding in the stock mag well and I need suggestions.</p><p>It looks great, but not perfect. When I get a chance to shoot it I will determine if I need to sand and float the barrel or bedding is in my future.</p><p>Need suggestions on sanding the mag well to get latch to seat under the mag catch and be less tight.</p><p>Reduction of the trigger pull to 2.6 is really feeling good and I think when my over sized fore and read grips will be helpful too.</p><p>[ATTACH=full]101937[/ATTACH] [ATTACH=full]101938[/ATTACH] [ATTACH=full]101939[/ATTACH] [ATTACH=full]101940[/ATTACH]</p></blockquote><p></p>
[QUOTE="steelfingers, post: 2995207, member: 38658"] Update. Pic one shows the mag catch that was not fitting in and needed a little sanding on the round end to fit. Once I did that I guess it positioned the take down screw where it would catch. When this was done I dropped in the barrel and attached. You will see a pic of the mag and note the mag latch is not low enough to capture the mag catch. Also still a bit of a tight fit. I can see some additional sanding in the stock mag well and I need suggestions. It looks great, but not perfect. When I get a chance to shoot it I will determine if I need to sand and float the barrel or bedding is in my future. Need suggestions on sanding the mag well to get latch to seat under the mag catch and be less tight. Reduction of the trigger pull to 2.6 is really feeling good and I think when my over sized fore and read grips will be helpful too. [ATTACH=full]101937[/ATTACH] [ATTACH=full]101938[/ATTACH] [ATTACH=full]101939[/ATTACH] [ATTACH=full]101940[/ATTACH] [/QUOTE]
Insert Quotes…
Verification
Post Reply
Forums
The Range
Gunsmithing & Repairs
Update on Boyd At One stock
Search titles only
By:
Top
Bottom