Forums
New posts
Search forums
What's new
New posts
New media
New media comments
Latest activity
Classifieds
Media
New media
New comments
Search media
Log in
Register
What's New?
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Navigation
Install the app
Install
More Options
Advertise with us
Contact Us
Close Menu
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Forums
The Range
Rifle & Shotgun Discussion
Winchester 94 30-30 from 1955 - how did I do and what is value?
Search titles only
By:
Reply to Thread
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="Catt57" data-source="post: 3489907" data-attributes="member: 34578"><p>Look for runs in the finish. Also check the fitment of the buttplate. 99% of people will end up rounding over the edge of the butt as it's extremely easy to do. Then the plate ends up proud of the stock. </p><p></p><p>Also check the edges of the barrel channel on the fore end. They typically should be sharp and crisp. Again, most people will end up rounding them over if they sand it at all.</p></blockquote><p></p>
[QUOTE="Catt57, post: 3489907, member: 34578"] Look for runs in the finish. Also check the fitment of the buttplate. 99% of people will end up rounding over the edge of the butt as it's extremely easy to do. Then the plate ends up proud of the stock. Also check the edges of the barrel channel on the fore end. They typically should be sharp and crisp. Again, most people will end up rounding them over if they sand it at all. [/QUOTE]
Insert Quotes…
Verification
Post Reply
Forums
The Range
Rifle & Shotgun Discussion
Winchester 94 30-30 from 1955 - how did I do and what is value?
Search titles only
By:
Top
Bottom