Shoulda warn a wig when you took that trump mask pic so they could not ID you!!I got a "delayed" from NICS. Crap. Gonna be awhile longer ...
Shoulda warn a wig when you took that trump mask pic so they could not ID you!!I got a "delayed" from NICS. Crap. Gonna be awhile longer ...
You aren't firing it folded are you?
Sorry it is a dumb question.
Not exactly sure how that folder is set up, never seen one physically. But bought a add on folder that I had same issue with. It turned out to be a issue with buffer retainer sticking up a little high. When you pulled charging handle back it slightly lifted bolt over it and worked fine but would not cycle when fired. Just something I ran into. Hope it helps or rules it out anyway.Got my 17 design folder assembled.
loving the design, but I cannot figure out while it’s not ejecting and chambering a round after a shot.
It’s not jaming I can pull charging handle and reload just fine.
it’s a 10.5” upper, and the upper was already assembled and on another lower prior and fired fine.
What am I missing??
Attached a couple pictures to just show it.
It’s the only way I’ve tried to install the front pivot pin
Did you build the upper or buy it complete?Got my 17 design folder assembled.
loving the design, but I cannot figure out while it’s not ejecting and chambering a round after a shot.
It’s not jaming I can pull charging handle and reload just fine.
it’s a 10.5” upper, and the upper was already assembled and on another lower prior and fired fine.
What am I missing??
Attached a couple pictures to just show it.
Enter your email address to join: