These bullets came with a big purchase so I know little about them. 2.8 pounds in zip lock bag. 4 bullets give an average weight of around 93 grains. 2.8 x 7000 / 93 gives a count of around 210 bullets. measured a couple at 0.3125" at the nose. dry lube over all the bullet. appeared to be...
I bought 1000 CCI small pistol primers in the carton box at Academy in Owasso over the weekend for ~$73 out the door. individual 100 cnt were $7.99 each. no shipping no hazmat
Ideal 575 OS 213 bullet mold 58 cal Old Style hollow base, nose pour. 460 grain bullet. Mold was part of a buy I made a few weeks ago. The mold does have surface rust. sprue rotates correct and is smooth on bottom. Will require a bit of cleaning and I believe the price reflect the effort. Have...
RCBS 2-Cavity Bullet Mold 37-250-FN 37 Caliber (376 Diameter) 250 Grain Flat Nose Gas Check, appears to be in NEW condition with original rust inhibitor, in box. 1 of 24 molds in a group buy. Will ship if payment details can be worked out. Price based on discount off Midway list.
the package I...
The thought was to use the Lee bullet sizing die and pin. the pin fits into the shell holder cut out in a ram. Have emailed rcbs as they sell a female shellholder by male thread adapter for older reloading presses. The adapter would allow me to adapt to either a custom made ram or to the rod...
I am going to build a automated bullet sizing machine. Looking for a reloading press ram as the basis. The though is to run the ram in bronze bushings in a custom built frame. would buy a press that the handle/linkage was non-functional or a press that someone wanted to get rid of at a lower...
Grangers and McMaster have open frame solenoids from $40 and up. been checking equipment salvagers to see if I can find something to play with that is a little less expensive.
not a liner but a linear solenoid is what I am looking for. Will be glad to post picks and parts as this progresses. I had read that the mica band heaters can play havoc with arc-fault breakers. This pot has not been used in years and probably absorbed moisture. Arc-fault is seeing a bit of...
Looking for electrical liner solenoid. I figure with the wide variety of experience on OK Shooter, someone might have some experience with linear solenoids and could steer me in the right direction. I have ordered a timing relay with display that I can set to around 0.5 second time. hoping to...
I figure with the wide variety of experience on OK Shooter, someone might have some experience with linear solenoids and could steer me in the right direction. I have ordered a timing relay with display that I can set to around 0.5 second time. hoping to find a 12vdc or maybe AC solenoid to use...
I am interested in providing a kit to homebuilt a machine similar to the MC. Providing the parts that require machining that the typical home shop would not be able to make. Not sure if it will actually happen. I also have an idea of how to increase the output of the machine. All this thinking...
drove up to Kansas to pick up a Magma manual Master Caster on Saturday. Very lightly used machine. It came with 24 sets off molds. Unfortunately only one mold is setup for the MC. a 454 LC 300 grain biggie. several 30 cal molds, 38, 44, 45, 50 and 58 cal. doubles and singles, Hollow point and...
just saw your WTB and was looking for this add. I believe I do still have. I am out of state until probably Thursday of this week if u can wait that long
I live south Tulsa / North Bixby. Will be in Florida most of Jan and Feb so may order primers over the next week.
Shop vac is close buy to pick up the bits of powder. I have closed up clearance on the Pro disk powder measure and a lot less flakes leaking thru. It is throwing pretty consistent...