Forums
New posts
Search forums
What's new
New posts
New media
New media comments
Latest activity
Classifieds
Media
New media
New comments
Search media
Log in
Register
What's New?
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Navigation
Install the app
Install
More Options
Advertise with us
Contact Us
Close Menu
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Forums
The Range
Handgun Discussion
10mm opinions?
Search titles only
By:
Reply to Thread
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="alank2" data-source="post: 1876144" data-attributes="member: 108"><p>Hi,</p><p></p><p></p><p></p><p>If you are using the factory barrel, you might not be able to reload (very much) them even if they were brass...</p><p></p><p>My first attempt at sizing some. I concluded that I was sizing too low, but my technique has always been to size a case as much as the die will let me. That doesn't work with the loose chamber in a Glock barrel. I even tried running them through a pass through die ahead of time and sizing them with similar results. From now on I'm running them through the pass through die (they will barely fit the chamber gauge after this) and then sizing only the area where the bullet is seated for case bullet tension. I can't wait for the Storm Lake barrel I ordered to arrive so I can test some more...</p><p></p><p><strong>[Broken External Image]</strong></p><p></p><p>Thanks,</p><p></p><p>Alan</p></blockquote><p></p>
[QUOTE="alank2, post: 1876144, member: 108"] Hi, If you are using the factory barrel, you might not be able to reload (very much) them even if they were brass... My first attempt at sizing some. I concluded that I was sizing too low, but my technique has always been to size a case as much as the die will let me. That doesn't work with the loose chamber in a Glock barrel. I even tried running them through a pass through die ahead of time and sizing them with similar results. From now on I'm running them through the pass through die (they will barely fit the chamber gauge after this) and then sizing only the area where the bullet is seated for case bullet tension. I can't wait for the Storm Lake barrel I ordered to arrive so I can test some more... [b][Broken External Image][/b] Thanks, Alan [/QUOTE]
Insert Quotes…
Verification
Post Reply
Forums
The Range
Handgun Discussion
10mm opinions?
Search titles only
By:
Top
Bottom