Forums
New posts
Search forums
What's new
New posts
New media
New media comments
Latest activity
Classifieds
Media
New media
New comments
Search media
Log in
Register
What's New?
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Navigation
Install the app
Install
More Options
Advertise with us
Contact Us
Close Menu
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Forums
The Range
Gunsmithing & Repairs
Custom Gun Shop!
Search titles only
By:
Reply to Thread
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="Master Carper" data-source="post: 3332386" data-attributes="member: 15527"><p>Dennis,</p><p></p><p>they can be used on several different platforms, that would accept a bull barrel. Mostly single shots and bolt actions. I however will NOT going to get into contouring barrels, been there done that!</p><p></p><p>Against all powers that be, I made a single barrel yesterday/last, night from beginning to end, starting with a piece of 20 ft. bar stock and finishing up with lead lapping the bore after everything else in between!</p><p></p><p>Cut, drilled, reamed, bored, rifled, ground finished, stress relieved, air gaged, lead lapped and faced on both ends! Finished diameter is 1.200" @ 27".</p><p></p><p>The barrel has a slight gold tint to it from the heat of stress relieving, but it will polish to a fine mirror finish!</p><p></p><p>This barrel is in 7mm and will go on a T/C Encore with the barrel remaining full diameter and cut back to 25" plus the addition of a muzzle brake. A friend from Muskogee has requested this, and has given me permission to post pictures of it when completed. </p><p></p><p>Chambering will be in my 7mm-444 Improved.</p><p></p><p>[ATTACH=full]155566[/ATTACH] </p><p></p><p>[ATTACH=full]155567[/ATTACH] </p><p></p><p>[ATTACH=full]155568[/ATTACH]</p></blockquote><p></p>
[QUOTE="Master Carper, post: 3332386, member: 15527"] Dennis, they can be used on several different platforms, that would accept a bull barrel. Mostly single shots and bolt actions. I however will NOT going to get into contouring barrels, been there done that! Against all powers that be, I made a single barrel yesterday/last, night from beginning to end, starting with a piece of 20 ft. bar stock and finishing up with lead lapping the bore after everything else in between! Cut, drilled, reamed, bored, rifled, ground finished, stress relieved, air gaged, lead lapped and faced on both ends! Finished diameter is 1.200" @ 27". The barrel has a slight gold tint to it from the heat of stress relieving, but it will polish to a fine mirror finish! This barrel is in 7mm and will go on a T/C Encore with the barrel remaining full diameter and cut back to 25" plus the addition of a muzzle brake. A friend from Muskogee has requested this, and has given me permission to post pictures of it when completed. Chambering will be in my 7mm-444 Improved. [ATTACH=full]155566[/ATTACH] [ATTACH=full]155567[/ATTACH] [ATTACH=full]155568[/ATTACH] [/QUOTE]
Insert Quotes…
Verification
Post Reply
Forums
The Range
Gunsmithing & Repairs
Custom Gun Shop!
Search titles only
By:
Top
Bottom
