Reply to Thread

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

Message: <blockquote data-quote="cal7.62x39" data-source="post: 3038259" data-attributes="member: 6824">So next part of weekend project is done!  I relocated the light pod mounts from apoc industries to the front to make the front attach point for some limb risers.  Flipping them around and using some eye bolts made the front easy work.  I got a 25 foot heavy duty dog cable on sale thats already got 2 heavy duty swivel clips.  I measured and cut the  cable to length and used a thimble and saddle clamps to make new loops.  I still need to trim it up a bit and shink the shrink wrap for a clean look.  I used turn buckles to be able to tighted and loosen as needed for attach/detach.  Then using some non load bearing carabiners I had laying around on the back of the rack for storage when not in use.  I still have about 13 feet of useable cable I am going to repurpose  with more thimble, saddle clamps, and shrink tube.  The big weak point on this is that I am using conduit hangers on the rack to support the cable.  I would like to find a P-clamp thats 1 1/4 to swap them out with, but it will work for now.  1-2 more projects to go this weekend stay tuned.[ATTACH=full]107418[/ATTACH] [ATTACH=full]107419[/ATTACH] [ATTACH=full]107420[/ATTACH] [ATTACH=full]107421[/ATTACH] [ATTACH=full]107422[/ATTACH] [ATTACH=full]107423[/ATTACH]</blockquote>