I've used Hornady One Shot for both rifle and pistol cases for several years and I've never experienced a stuck case (knock on wood).....as someone mentioned I think the key is to stand them up in a reloading tray while spraying being sure to get some inside the necks.
I got a few tubes of the Lee case lube - that white stuff in a tube.
I mix it in 99% isopropyl alcohol. About 1.5" squirt of Lee lube in a 4 ounce spray bottle. Shake shake shake. Lay out brass on a sheet, spray three or 4 times. Let it dry, roll the brass over, repeat. It doesn't take much.
The mix dries very quickly, leaves a slight white film on the brass. It's a waxy feel, works fine.
No need to clean it off. It's not messy, not sticky, no staining. I just load it and shoot.
I mix it in 99% isopropyl alcohol. About 1.5" squirt of Lee lube in a 4 ounce spray bottle. Shake shake shake. Lay out brass on a sheet, spray three or 4 times. Let it dry, roll the brass over, repeat. It doesn't take much.
The mix dries very quickly, leaves a slight white film on the brass. It's a waxy feel, works fine.
No need to clean it off. It's not messy, not sticky, no staining. I just load it and shoot.
Ive used them all. But once I started to make my own the store bought stuff has just sat on the shelf
A very Little bit of lanolin (liquid not paste) and highest percent alcohol. A large sprayer comes out to about a buck or so and lasts quite a while
A very Little bit of lanolin (liquid not paste) and highest percent alcohol. A large sprayer comes out to about a buck or so and lasts quite a while
Fuel dryer -red bottle "Heat " = Highest % of alcohol . 4-1 mix alcohol to lanolin is my go to lube ,mix a qt up in a spray bottle . If your reloading room gets cold in the winter ,pull the sprayer or the lanolin will pug it up .
I have dies on my bench, right now, with stuck cases using One Shot. .30-06, .260Rem, .44Mag and .223
Bought carbide dies for all my pistol calibers.
Using the old pad and RCBS, never a problem.
The One Shot gets sprayed IN the rifle dies and on press ram arm.
I will get some lanolin and isopropyl, when the RCBS gets used up.
PSA: Walgreens has 99% isopropyl.
Using STP on a pad for over 50 years . Never had a stuck case.
I love One-Shot on pistol even though I only use carbide dies. It really smooths up the process.
But, I won’t use it on rifle for exactly that reason.
I use Dillon or the copy-cat recipe on rifle.
What are the sources for the suggested lanolin?
Liquid Lanolin. I bought mine from Amazon. I believe it can be found at CVS or Walgreens. Tell them it is for your nipples.
Similar threads
