Reply to Thread

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

Message: <blockquote data-quote="n8thegr8" data-source="post: 2214202" data-attributes="member: 6349">well, I dun fooked up one too many times. While reaming the barrel pin hole, I egged it out. I tried again, this time triple checking that everything was square, ran a slightly larger drill bit through, and egged it out even worse. the egged out side of the trunnion is about 8.3mm, and the largest your supposed to be able to go is 8mm, so I think the front trunnion, and the barrel probably, are toast at this point.Anyone know of a gunsmith who could fix my screw-up? or should I just demill the trunnion and put the whole shebang on gun broker?</blockquote>