Reply to Thread

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

Message: <blockquote data-quote="TheLastDaze" data-source="post: 2565803" data-attributes="member: 10463">I let it get low a couple times like down to 7 primers, maybe that's why I seated one primer sideways ..... <img src="/images/smilies/redface.png"  class="smilie" loading="lazy" alt=":o" title="Embarrassment    :o" data-shortname=":o" />ops:you are correct 5.7gr weighed 8 x before loading and was dead on, after loading about 200 rds I checked weight again and was perfect... lee's charts don't show the CFE, so it took some trial and error and a little powder spilled before I got the right one I needed, .41cc.so do you think I could load .380 with these dies?? my thinking is I would just have to set the dies down lower to accommodate for shorter casing...and I completely see why you run your press the way you do, but for me being a beginner It would prove very difficult.. I pulled a couple casings that didn't get any powder (chain came loose) later I rant them through and skipped the decapping die, but on one I forgot.... and out came a new primer, I took it slow and easy for the most part and I would say took 2.5hrs for the 630 rds I made...</blockquote>