Reply to Thread

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

Message: <blockquote data-quote="rawhide" data-source="post: 4108422" data-attributes="member: 3448">Began this morning with the same tool I used earlier this week. Worked well ob light rust, but the heavy rust ate it up quickly. Took [USER=43171]@Cowcatcher[/USER] 's advice and drove to Tulsa and picked up the surface conditioning tool. Far better than a wire brush and file. Cleaned 31' joint of 2 7/8 in about 10 minutes. Finished all of the overhead gate pipe and started on the entrance. Working horizontal at waist high is much easier than vertical post. That tool is heavy.  Good thing I got an extra 40 gri drum, the original is only [ATTACH=full]407555[/ATTACH][ATTACH=full]407556[/ATTACH]good now for curved surfaces. First pic is after about 15 seconds of work. [ATTACH=full]407554[/ATTACH]</blockquote>