Forums
New posts
Search forums
What's new
New posts
New media
New media comments
Latest activity
Classifieds
Media
New media
New comments
Search media
Log in
Register
What's New?
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Navigation
Install the app
Install
More Options
Advertise with us
Contact Us
Close Menu
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Forums
The Range
Rifle & Shotgun Discussion
Remington model 11 barrel
Search titles only
By:
Reply to Thread
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="Bfahrny56" data-source="post: 3725856" data-attributes="member: 48310"><p>I have a Remington model 11 in 12 ga that I have been on the lookout for a replacement barrel with little luck. It looks as if I'm going to have to change direction and try to have the original barrel repaired. The problem is that at some time in it's life, someone cut the vent rib off the barrel ( support ribs to it were integral to the barrel), then at some point, another rib was soldered on. Apparently, the rib would not allow the barrel to recoil properly and it was removed. I would like to find a good gunsmith in the area along the I44 corridor (Chandler to Tulsa) capable of restoring this to close to original condition . Or at least finding out if it's financially practical. </p><p></p><p> Thanks</p></blockquote><p></p>
[QUOTE="Bfahrny56, post: 3725856, member: 48310"] I have a Remington model 11 in 12 ga that I have been on the lookout for a replacement barrel with little luck. It looks as if I'm going to have to change direction and try to have the original barrel repaired. The problem is that at some time in it's life, someone cut the vent rib off the barrel ( support ribs to it were integral to the barrel), then at some point, another rib was soldered on. Apparently, the rib would not allow the barrel to recoil properly and it was removed. I would like to find a good gunsmith in the area along the I44 corridor (Chandler to Tulsa) capable of restoring this to close to original condition . Or at least finding out if it's financially practical. Thanks [/QUOTE]
Insert Quotes…
Verification
Post Reply
Forums
The Range
Rifle & Shotgun Discussion
Remington model 11 barrel
Search titles only
By:
Top
Bottom