Shop cooling suggestions

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Joined
Apr 7, 2009
Messages
16,356
Reaction score
12,086
Location
Tulsa
I have an all-metal shop built on a concrete slab, 30’ x 40’ with a 12’ high center ridge. The walls are sheet metal with a little insulation there and on the ceiling. Two metal side doors at opposite ends and an overhead door. No windows.

No heat or air, either. It’s not so bad in the winter, as I can set a space heater on the floor near where I’m working, but the summer heat and humidity are a bear, and I can handle only an hour or two right after sunrise. I can keep working, but being hot and sweaty leaves me grumpy, which defeats the purpose of tinkering in the shop. I’ve been looking at ways to cool the space at least to 80 degrees, with a budget of $500. I can get a pretty good sized swamp cooler at that price point, and put it in front of one open door, pointing toward the other open door. I’ve seen charts that indicate a temp of 80 degrees is doable if the outside temp is no more than 90 and the relative humidity no more than about 65%.

Has anyone east of I-35 actually run a swamp cooler in the summer in recent years? If so, how well did it work? Any other suggestions without going over $500?
 

TwoForFlinching

Sharpshooter
Special Hen
Joined
Aug 14, 2012
Messages
10,517
Reaction score
5,915
Location
Lawton
Can't run them old swamp coolers in the wood shop, but having a really high cfm "whole house" type fan does wonders. Open up the windows on the far end of the shop, turn on the fan in the other end. It doesn't create breeze, but it keeps air moving well enough to keep the inside cooler than the outside.
 

NightShade

Sharpshooter
Special Hen
Joined
Apr 24, 2013
Messages
4,116
Reaction score
1,812
Location
Guthrie
If you have an air compressor and it's only you working I would look at one of the vests that connects to shop air. https://www.amazon.com/Conditioner-Waistcoat-Compressed-Cooling-Welding/dp/B01N3OLJ5Z

Otherwise open the doors and run fans.

Make sure the place is able to breathe at night and vent the heat from the day as well either way if that heat is trapped in there the place will never feel cool so that may require a fan in a wall to draw in and another in the roof/ceiling to draw out when you shut down for the night. The next day come in and shut them down before it starts to heat up. And start working as early as you can. I worked at a place doing modular homes and we were done by noon after putting in 8 hours during the summer.
 

Glock 40

Problem Solver
Special Hen
Joined
Jun 14, 2005
Messages
6,284
Reaction score
9,527
Location
Tulsa

NightShade

Sharpshooter
Special Hen
Joined
Apr 24, 2013
Messages
4,116
Reaction score
1,812
Location
Guthrie
Yeah if you keep cool packs around that will work. I have a think called an iceman that I used to use when I had a car without ac. Throw some ice and water in it and it will keep you fairly cool for a while. You can find then cheap on Ebay or just make a short with some icemaker water line running through it and a manifold then run a large line in and a similar size line out to a freezer and put a pump at some point. Fill the freezer with water and mix up some anti freeze in a seperate reservoir and run some lines into the freezer. When it's a solid block of ice you are going to stay cool.
 

Glock 40

Problem Solver
Special Hen
Joined
Jun 14, 2005
Messages
6,284
Reaction score
9,527
Location
Tulsa
Hey that reminded me. Years ago a guy I worked with a guy talked about sweat wicking dew rags. Man they work I always wear one when it gets hot and I am in the garage or doing yard work. Also the neck cool towels which are just like a chamois also work great. Just some ideas to help keep you cooler while your working.
 

Latest posts

Top Bottom