Reply to Thread

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

Message: <blockquote data-quote="Chard" data-source="post: 2081114" data-attributes="member: 2454"><p>Very easy to do. The 10 rounders are actually 25 rounders. Take a small screwdriver and insert it into the follower. It has a round hole in it. Press down untill it will not travel anymore. This is where the roll pin is located. Take the bottom plate off. Remove the spring. Take a long thin screw driver and insert inside the mag. Center the blade of screwdriver on the roll pin. I used a small 4oz ball pein hammer. I had to smack it 10-12 times to bend the roll pin. It will eventually  bend to a point that it will fall out. Reassemble mag and your good to go. Clear as mud?</p></blockquote><p></p>