Forums
New posts
Search forums
What's new
New posts
New media
New media comments
Latest activity
Classifieds
Media
New media
New comments
Search media
Log in
Register
What's New?
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Navigation
Install the app
Install
More Options
Advertise with us
Contact Us
Close Menu
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Forums
The Range
Rimfire Weapons
Start of my new 10/22 build
Search titles only
By:
Reply to Thread
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="BReeves" data-source="post: 1520238" data-attributes="member: 10973"><p>Yes, not really that hard to do. Just need some way to make the spacing consistent. I clamped the bolt on my mini-mill and used the mill table to accurately set/move the spacing. Used a 1/4 inch brass rod with sticky-back fine sandpaper circles punched out with a paper punch stuck on the end. Chucked it in a drill chuck on the mill and went at it. Not really the proper tool but it worked..</p></blockquote><p></p>
[QUOTE="BReeves, post: 1520238, member: 10973"] Yes, not really that hard to do. Just need some way to make the spacing consistent. I clamped the bolt on my mini-mill and used the mill table to accurately set/move the spacing. Used a 1/4 inch brass rod with sticky-back fine sandpaper circles punched out with a paper punch stuck on the end. Chucked it in a drill chuck on the mill and went at it. Not really the proper tool but it worked.. [/QUOTE]
Insert Quotes…
Verification
Post Reply
Forums
The Range
Rimfire Weapons
Start of my new 10/22 build
Search titles only
By:
Top
Bottom