Forums
New posts
Search forums
What's new
New posts
New media
New media comments
Latest activity
Classifieds
Media
New media
New comments
Search media
Log in
Register
What's New?
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Navigation
Install the app
Install
More Options
Advertise with us
Contact Us
Close Menu
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Forums
The Range
Ammo & Reloading
Store prepped brass primed?
Search titles only
By:
Reply to Thread
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="Rez Exelon" data-source="post: 4018265" data-attributes="member: 5800"><p>HA! You know I thought I'd blame you for my problems with this batch, but I cheated on your and got a couple of boxes from a member in KS when I was driving through a few years ago. Reason I thought to blame you was A) to give you a hard time and B) because I didn't quite want to go through 2500 pieces of brass today.</p><p></p><p>However, things being what they were I noticed a few thousand rounds into processing that some of the flash holes in the brass were cut off center. Now, technically they did make it through my sizing die, but I figure that might lead to inconsistency down the road, and if I ran them through again, maybe it wouldn't be as nice to my dies. So I had to go through every dang piece checking the flash holes again. Wound up culling about 60 pieces out of the 2500ish. Of those, 90% were Aguilla.</p></blockquote><p></p>
[QUOTE="Rez Exelon, post: 4018265, member: 5800"] HA! You know I thought I'd blame you for my problems with this batch, but I cheated on your and got a couple of boxes from a member in KS when I was driving through a few years ago. Reason I thought to blame you was A) to give you a hard time and B) because I didn't quite want to go through 2500 pieces of brass today. However, things being what they were I noticed a few thousand rounds into processing that some of the flash holes in the brass were cut off center. Now, technically they did make it through my sizing die, but I figure that might lead to inconsistency down the road, and if I ran them through again, maybe it wouldn't be as nice to my dies. So I had to go through every dang piece checking the flash holes again. Wound up culling about 60 pieces out of the 2500ish. Of those, 90% were Aguilla. [/QUOTE]
Insert Quotes…
Verification
Post Reply
Forums
The Range
Ammo & Reloading
Store prepped brass primed?
Search titles only
By:
Top
Bottom