Interesting that just the neck has enough area to stick!
Tannerite
You'll scratch the die.
Well nothing seems to be working so it kinda looks like a trip to Jerry's for that extraction tool is in my future.
That ain't necessarily such a bad thing though considering the other stuff they have there...
That ain't necessarily such a bad thing though considering the other stuff they have there...
Last edited:
Yep. Just buy the kit and hang onto it. If you reload long enough, you'll need it again. I reloaded for quite a few years before the need arose.
Drop the whole thing in a can of penetrating oil and leave it sit overnight then tomorrow use a punch that'll fit down through the die and neck and drive it out......good luck.
Drill the primer hole, thread with a 1\4 inch tap, put your in your press from the bottom up, and use
A small slide hammer and pull brass.
Or buy the the stuck case tool, works.good also if you have on hand.
Don't forget to back your decapper all the out
Good luck
A small slide hammer and pull brass.
Or buy the the stuck case tool, works.good also if you have on hand.
Don't forget to back your decapper all the out
Good luck
I reloaded for decades before sticking a case. It was, coincidentally, a 223 also.
I had acquired a stuck case tool setup in a trade at some point; it worked perfectly.
This works.
