Forums
New posts
Search forums
What's new
New posts
New media
New media comments
Latest activity
Classifieds
Media
New media
New comments
Search media
Log in
Register
What's New?
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Navigation
Install the app
Install
More Options
Advertise with us
Contact Us
Close Menu
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Forums
The Range
Gunsmithing & Repairs
Timney 641C trigger install in Ruger American
Search titles only
By:
Reply to Thread
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="steelfingers" data-source="post: 2986160" data-attributes="member: 38658"><p>Part two. Pic 9 remove rear pin. Pic ten remove trigger. Remove blot lock clip, spring, safety bar from old trigger. Push in bolt lock from left side of trigger to get clip off. Note which hole the spring goes on housing. Pic eleven is bolt lock clip from old trigger installed in new trigger. Twelve is install of bolt lock spring and safety bar installed from left side. Note that safety button in in the correct position with the eye hole pointed forward. Thirteen is trigger dropped in attached to safety button and pins tapped in. Fourteen is the finished product. 3 lb pull that is perfect. Damn this is a great trigger.</p><p>[ATTACH]100857[/ATTACH] [ATTACH]100858[/ATTACH] [ATTACH]100859[/ATTACH][ATTACH]100861[/ATTACH] [ATTACH]100862[/ATTACH] [ATTACH]100863[/ATTACH]</p></blockquote><p></p>
[QUOTE="steelfingers, post: 2986160, member: 38658"] Part two. Pic 9 remove rear pin. Pic ten remove trigger. Remove blot lock clip, spring, safety bar from old trigger. Push in bolt lock from left side of trigger to get clip off. Note which hole the spring goes on housing. Pic eleven is bolt lock clip from old trigger installed in new trigger. Twelve is install of bolt lock spring and safety bar installed from left side. Note that safety button in in the correct position with the eye hole pointed forward. Thirteen is trigger dropped in attached to safety button and pins tapped in. Fourteen is the finished product. 3 lb pull that is perfect. Damn this is a great trigger. [ATTACH]100857[/ATTACH] [ATTACH]100858[/ATTACH] [ATTACH]100859[/ATTACH][ATTACH]100861[/ATTACH] [ATTACH]100862[/ATTACH] [ATTACH]100863[/ATTACH] [/QUOTE]
Insert Quotes…
Verification
Post Reply
Forums
The Range
Gunsmithing & Repairs
Timney 641C trigger install in Ruger American
Search titles only
By:
Top
Bottom