Reply to Thread

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

Message: <blockquote data-quote="panayoti" data-source="post: 3977427" data-attributes="member: 428"><p>Nice machine. You might take the cover off and blow out the dust in internal parts. Make sure you clean your metal where your bead will be. Mig won't burn through crud like 6010/6011 stick. Looks like a good ground clamp. Make sure you weld in well ventilated area flux core smoke is nasty. You might section some of your welds to see if you are getting good penetration. A downside of mig is you can have a pretty looking weld but not have any penetration. You get most of the strength down in the root. I am sure I will get comments from the adolescents on this board. There are tons of welding vids in you tube.</p></blockquote><p></p>